Aem 30-2310 Inline Wideband UEGO Controller Manual de usuario descargar pdf (Pagina 6)

Page 6

Inline Wideband UEGO/AEM F/IC Configuration

With an FIC calibration open, go to Setup>Aux Gauge, and complete the Aux gauge

setup window as shown below in Figure 5.

Figure 5. F/IC Aux Gauge Setup

Connect the WHITE Analog Output + wire to the Aux Gauge input and the BROWN

Analog Output – wire to the sensor ground. Table 5 below lists the Lambda and Sensor

ground pin locations for the different FIC part numbers.

AEM F/IC P/N Lambda Pin Sensor GND Pin

30-1910(X) Pin 18 of 22-pin connector Pin 5 of 22-pin connector

30-1930(X)

Pin 18 of 22-pin connector

Pin 20 of 20-pin connector

Pin 5 of 22-pin connector

Table 5. F/IC Pin Locations

Displaying Data with a PC/Laptop

Real time AFR data can also be viewed via a pc/laptop using an RS232 serial port

connection. Download the data viewer program and instructions from the AEM

Performance Electronics forum at www.aemelectronics.com

. . See figure 6.

1 2 3 4 5 6 7 8

Sin comentarios

Aem 30-2310 Inline Wideband UEGO Controller Manual de usuario Pagina 6