Aem 30-3432 Series 2 AEMnet Adapter Manual de usuario descargar pdf (Pagina 2)

Page 2

AEMnet CONNECTORS

The AEMnet has four wires, two are for communication (white pin 1 and green pin 2) and two are for

powering (red pin 3 and black pin 4) certain AEMnet devices. Only the two communication wires

(white pin 1 and green pin 2) are needed for the Series 2 EMS to send/receive data as the EMS is not

EMS with devices that are powered by AEMnet such as the Dyno-Shaft (see individual instructions for

details). The AEMnet connectors are shown below in figure 1. See table 1 for the AEMnet connection

pinout.

Figure 1: AEMnet connectors, wire entry view

AEMnet Connector Series 2 EMS Connector

Pin 1 White CAN1H

Pin 2 Green CAN1L

Pin 3 Red AEMnet Power (switched 12 volts)

Pin 4 Black AEMnet Ground

Table 1: AEMnet connector pinout

1 2 3 4 5 6 7 8

Sin comentarios

Aem 30-3432 Series 2 AEMnet Adapter Manual de usuario Pagina 2